GMC-7.0 motor-cultivator

Huter GMC 7.0 is rather powerful and reliable motor - cultivator of the German production. The tool is specially developed for personal use on a personal plot, a kitchen garden.

He can carry out works of easy and average intensity on processing of the soil with the agricultural purposes. It is possible to refer plowing, cultivation to such works and other.

With it the device is helped by a reliable and powerful petrol single - cylinder four - cycle internal combustion engine on air cooling. Power of OHV DVS reaches decent 7 hp.
The engine settles down approximately in the center of a frame which plays a case role. Moreover the engine is not covered with the protection cover that is defined by existence of natural cooling.

Fuel comes to the engine by drift therefore the gasoline tank for AI - 92 gasoline is on DVS. The model is equipped with three transfers (two lobbies and one back).
Start of the engine is carried out by means of a manual hummock starter.

The power block and the block of processing are divided by special filters. These guards rescue the operator from dispersion of the soil and dirt, and also from possible injuries and damages.

The block of processing is presented by mills with a diameter of 320 mm. They are capable to carry out processing of the soil on depth to 300 mm. And here width of processing of the earth can change depending on quantity of the used mills within 610 - 830 mm. Such parameters quite are enough for individual works on the land plot.

On a surface the motor - cultivator of Huter GMC 7.0 moves by means of a wheel of management and two roundish support of mills on each side. The wheel of management is mobile, serves for the choice of the direction of the movement.
It copes with the help of the bicycle handle of management in the most back part of a design. Also on the handle of management there are principal organs of control of the tool.