Color sand - a rough covering of a floor
- Customer pickup,
- Courier
- In detail
- Country of manufactureKazakhstan
- Type of filling floorEpoxy
Color sand" - a rough covering
Application: The decorative, not slippery coverings of a floor maintaining mechanical influences of moderate intensity at the movement of wheel transport on rubber and plastic to the course, pedestrians and carts on rubber and plastic to the course and also chemical influences of fuels and lubricants, acids and alkalis of average intensity, and water - big intensity.
№ | Operation | Material | Expense
kg/sq.m |
Tool,
way |
1. | Primer | Ризопокс™ - 1100 | 0.3 ¸ 0.4 | Roller resistant to solvents
with a pile length the 15-18th |
Powder | The calcinated quartz sand, fraction
0.4 ¸ 0.8mm or 0.8 ¸ 1.4mm |
0.4 ¸ 0.5 | Manually
The amount of sand on powder depends on the chosen fraction of sand. At the choice of large fractions it is necessary to appoint maximum expense. |
|
2. | Front layer | Ризопокс™ - 1605 | 0.8 ¸ 1.0
1.2 ¸ 1.4 |
Metal scraper or
trovel without teeths The expense of structure depends from fractions of sand, which applied at a stage No. 1. Expenses correspond to fractions of sand: 0.4 ¸ 0.8mm 0.8 ¸ 1.4mm |
Filling | Color quartz sand of the Rizodek™ brand, fraction
0.4 ¸ 0.8mm or 0.8 ¸ 1.4mm |
3.0 ¸ 3.5
3.5 ¸ 4.0 (depending on fraction of sand at a stage No. 1) |
Manually to a state "under a fur coat". | |
3. | Sand cleaning.
Preparation of a surface. |
Sweep away excess sand.
To smooth out a surface metal scraper, rigid brush or emery cloth of big fineness. To remove dust industrial vacuum cleaner. |
||
4. | Impregnation | Ризопокс™ - 1605 * | 0.4 ¸ 0.61
0.55 ¸ 0.72 |
To put structure rubber
pallet "on sdir". The expense of impregnating depends on extent of pressing on the pallet structure. |
TOTAL |
Note: * to pay special attention to an expense and uniformity of drawing Rizopoks™-1605. Not to allow drawing by a thick layer, formations of pools and potek, otherwise there can be a yellowing of a finishing layer under the influence of a sunlight. In need of higher light resistance to use the material Rizopoks™-1606 as a finishing layer.
1 - for color sand of fraction of 0.4-0.8 mm
2 - for color sand of fraction of 0.8-1.4 mm
General thickness: 2.8 ¸3.0 mm